SAFETY ADVICES
2019-04-30 8
AFS670 | PRECAUTIONS AND SAFETY
3 Safety Advices
DANGER Non-observance can lead to death or injury.
Only authorized and properly trained personnel is admitted to carrying out
the following equipment tasks:
• Installation, commissioning, maintenance, decommissioning and disposal.
DANGER Non-observance can lead to death or injury.
The equipment should be configured by a trained person, who has good
knowledge on Ethernet and AFS670 V2.0 device.
DANGER Non-observance can lead to death or injury.
The equipment should be only put in operation after being fully and correctly
configured.
DANGER Non-observance can lead to death or injury.
The Precautions and Safety document should be read and clearly understood
before working with the equipment.
DANGER Non-observance can lead to death or injury.
The warning labels regarding precautions and indications of hazardous volt-
ages and hazardous energy levels must be strictly observed.
DANGER Non-observance can lead to death or injury.
Mechanical safety facilities such as cover plates must not be removed or
bypassed during operation.
DANGER Non-observance can lead to death or injury.
Alteration of the equipment is not allowed.
DANGER Non-observance can lead to death or injury.
The equipment must only be transported, stored and operated in environ-
ments according to the environmental specification, see section Ambient
Conditions
. This applies also for any attached cables.
DANGER Non-observance can lead to death or injury.
In case the equipment is mounted vertically the equipment should be
mounted in a fire protection wrapping according EN 60950-1.
DANGER Non-observance can lead to death or injury.
Equipment might be connected to high voltages and can cause an electric
shock when incorrectly installed.
→ Do not touch any live wires or related wire contacts.
To Next Page
Loading...
