ABB AFS670 - EMC Specifications (Continued); Stability Specifications (Vibration and Shock); High Voltage Power Supply Interface

EQUIPMENT SPECIFICATION
2019-04-30 16
AFS670 | PRECAUTIONS AND SAFETY
Electrostatic discharge EN 61000-4-2 IEEE C37.90.3
Contact discharge ±8 kV
EN 61000-4-2 IEEE C37.90.3
Air discharge ±15 kV
- Electromagnetic field EN 61000-4-3 80 MHz ..3000 MHz
max. 10 V/m
IEEE 1613 80 MHz ...1000 MHz
35 V/m
Fast transients (burst) EN 61000-4-4 IEEE C37.90.1 DC supply connection
±4 kV
EN 61000-4-4 IEEE C37.90.1
Data line ±4 kV
Voltage surges - DC supply connection EN 61000-4-5 line/ground ±2 kV
IEEE 1613 line/ground ±5 kV
EN 61000-4-5 line/line ±1 kV
Voltage surges - data line EN 61000-4-5 line/ground ±2 kV
Conducted disturbances EN 61000-4-6 150 kHz ... 80 MHz 10 V
Damped oscillation - DC supply connection EN 61000-4-12 IEEE C37.90.1 line/ground 2.5 kV
EN 61000-4-12 IEEE C37.90.1 line/line 1 kV
Damped oscillation - data line EN 61000-4-12 IEEE C37.90.1 line/ground 2.5 kV
EN 61000-4-12 line/line ±1 kV
Table 4: Stability
Parameter Specification
Vibration IEC 60068-2-6, test Fc
2 Hz ... 9 Hz with 3 mm (0.11 in) amplitude 9 Hz ... 200 Hz
with 1 g
200 Hz ...500 Hz with 1.5g
Shock IEC 60068-2-27, test Ea
10 g at 11 ms
Table 5: Interface Power Supply High Voltage
Parameter Specification
Rated voltage 110 V AC ... 240 V AC, 50 Hz ... 60 Hz
110 V DC ... 250 V DC
Voltage range including maximum toler-
ances
88 V AC ... 276 V AC
88 V DC ... 288 V DC
Connection type 3-pin terminal block
Tightening torque 0.5 Nm (4.4 lb-in)
min. conductor diameter
Supply with AC voltage: AWG18 (0.75 mm²)
Supply with DC voltage: AWG16 (1 mm²)
max. conductor diameter: AWG12 (2.5 mm²)
Power loss buffer >20 ms at 230 V DC
Back-up fuse for each voltage input Nominal rating: 2.5 A
Characteristic: slow blow
Table 3: EMC (continued)
Parameter Specification