ABB AWT420 - Electrical installation; Earth bonding

12
AWT420 | UNIVERSAL 4-WIRE, DUAL-INPUT TRANSMITTER | INF/ANAINST/012-EN REV. A
…4 Hazardous area considerations
…Fitting the hazardous location EZLink bulkhead connector
Referring to Figure 7:
7 Fit alignment tab I into gland plate slot K into the casting
slot.
8 Insert EZLink bulkhead connector body L fully into cable
entry and align the bulkhead connector body using the flats
on the alignment washer (see , item H).
9 Screw back nut J onto bulkhead connector body and


Figure 7 Securing the EZLink bulkhead connector cable
Referring to Figure 8:
10 Place EZLink cable plug M into EZLink bulkhead connector
block cradle A.
11 Attach EZLink bulkhead cable bung O to cable loom and
push bung forward to cover connection plug M.
12 Plug assembled connector block cradle/cable plug/bung
into EZLink module P.
Figure 8 Connecting the EZLink cable assembly
Referring to Figure 7:
13 Push EZLink bulkhead label Q onto bulkhead connector
body R.
14 Fit bulkhead dust cap S onto bulkhead connector body R.
15 
16 Close and lock transmitter door B.
K
I
J
L
Q
R
S
B
I
A
M
O
P
A