ControlMaster CM30, CM50 and CMF310
Universal process controllers,
1
/4,
1
/2 DIN and fieldmount 7 Advanced Level
IM/CM/ED–EN Rev. X 69
…Profile Parameters
Enter Program
Program No. Select the program to be configured (1 – 30).
Name Enter the Program Name (up to 16 characters) to be used to identify the running
program in the Operator Page display.
Repeat Count Enter the number of times the program is to be repeated.
None The program will not be repeated (it will run once).
1 … 10 The program repeats as defined, for example, if '1' is selected the program runs twice.
Continuous The program runs continuously until stopped by the operator.
Setpoint Start/End
Start The start setpoint value for the first segment of the program.
Note. Available only if the SPT Start Condition parameter is set to Program Setpoint.
End Defines the end condition of the program:
Local Setpoint
The program will enter the Stop state and switch to the currently selected Local
Setpoint.
Hold Setpoint
The program remains active and in control at the setpoint defined by the last segment. It
remains active until stopped, at which point the Control Setpoint switches to the current
Local Setpoint.
Jump Program
At the end of the program, the profiler jumps to the start of another configured program.
Jump To Program Define the next program that the profiler will jump to on completion of the current
program.
Note. Available only if Setpoint End condition is set to Jump Program.
Holdback Hysteresis Hysteresis values are used to hold the program when the process value deviates from
the setpoint by more than the hysteresis value as defined by the Guaranteed Ramp
option for each segment.
Note. Available only if Guaranteed Ramp is enabled.
Soak Set the hysteresis value applied to Soak segments.
Ramp Set the hysteresis value applied to Ramp segments.
To Next Page
Loading...
