To Next PageTo Next Page
Need help?Do you have a question about the ABB ControlMaster CM50 and is the answer not in the manual?
General| Model | ControlMaster CM50 |
|---|---|
| Type | Process Controller |
| Input Types | Thermocouple, RTD, mV, V, mA |
| Output Types | Relay, Analog |
| Communication Protocols | Modbus RTU, Ethernet |
| Power Supply | 100 to 240 V AC or 24 V AC/DC |
| Operating Temperature | -10 to 55°C |
| Control | PID |
Safety requirements for electrical equipment.
Guidelines for controller placement and environment.
Procedures for panel mounting the controller.
Important warnings and guidelines for electrical connections.
Wiring diagram for CM10 controller electrical connections.
Wiring diagram for CM30 controller electrical connections.
Wiring diagram for CM50 controller electrical connections.
Diagrams and notes for standard analog inputs.
Access to standard setup parameters for control/indication.
Configuration of analog and digital inputs/outputs and relays.
Configuration of setpoints, control functions, and outputs.
Configuration of up to 8 independent process alarms.
Setpoint profile generator for complex setpoint control.
How program status is set to HOLD and ramp/soak applied.
Parameters for math blocks, logic equations, and timer functions.
Viewing diagnostic data and recommended corrective actions.
Configures ControlMaster as backup for Master Controller.
Backup for master controller with remote/local control modes.
