ABB DATUM L160 - Page 12

10
…2 OPERATOR MODE
…2.3 Operating Page – Max./Min./Average Functions (Level 1)
•1 The maximum and minimum values are reset automatically on power-up and
can also be reset from a digital input – see Section 4.3.4.
------
rSt-n
H150.2
rSt-n
L130.8
CodE
•1
•1
LEVEL1
G1.000
Maximum Value
This is the maximum value of the process variable
since the maximum was reset.
To reset the maximum value, select
rSt-Y then
press the
key.
rSt-Y – reset
rSt-n – do not reset
Minimum Value
This is the minimum value of the process variable
since the minimum was reset.
To reset the minimum value, select
rSt-Y then
press the
key.
rSt-Y – reset
rSt-n – do not reset
Specific Gravity
This is the value of specific gravity currently being
applied to the process variable (display only).
Security Code
Enter the correct code to access the Set Up Level
(Level 2) or the Configuration Level (levels 3 and 4).
[0 to 9999]
Level 1
Note. To select this frame from anywhere in
this page, press the
key for a few seconds.