9
2 OPERATOR MODE…
2.3 Operating Page – Max./Min./Average Functions (Level 1)
See Section 4.3.3 for details of Max./Min./Average functions.
•1 The average value is displayed only if enabled in the configuration level –
see Section 4.3.3
The average value is reset automatically on power-up and can also be reset
from a digital input – see Section 4.3.4.
rSt-n
2145.3
UN-ACK
A 140.5
H150.2
•1
Measured Level
To view the input value (in electrical units) press the
key.
Global Alarm Acknowledge (latch alarms only)
UN-ACK. – alarm unacknowledged
ACK. – alarm acknowledged
Average Value
This is the mean average value of the process
variable, since the average was reset.
To reset the average value, select
rSt-Y then press
the
key.
rSt-Y – reset
rSt-n – do not reset
Continued on next page.
To Next Page
Loading...
