ABB DATUM L160

13
8
…3 SET UP MODE
3.2 Set Up Level (Level 2)
Level 2
Note. To select this frame from anywhere in this
level, press the
key for a few seconds.
Alarm 1 Trip Point
Alarm type:
A1.hP = High level alarm
A1.LP = Low level alarm
A1.HL = Latched high level alarm
A1.LL = Latched low level alarm
A1.Fr = Fast rate level alarm
A1.Sr = Slow rate level alarm
[In engineering units or % of engineering
span per hour]
Alarm 1 Hysteresis
Not applicable to
A1.Fr and A1.Sr alarm type.
[Process alarms – engineering units]
Alarm 2 Trip Point
Alarm type
[In engineering units or % of engineering
span per hour].
Alarm 2 Hysteresis
Not applicable to
A2.Fr and A2.Sr alarm type.
[ in % engineering range]
Continued on next page…
200.2
A1.hP
100.1
A2.LP
LEVEL2
•1
•1
A1.HYSt
100.0
A2..HYSt
20.0
A3.hP
•2
•2
•1 Not displayed if the alarm is disabled ('None' selected) – see Section 4.3.2.
•2 Only displayed if custom alarm hysteresis is selected – see Section 4.3.2
(not displayed for rate alarms).