ABB Excount II - 5.3 Making Measurements; 5.3.1 Leakage Current Measurement; 5.3.2 Surge Counter Data Reading

46
1HSA 801 080-15en EXCOUNT-II Users Manual
5. Transceiver menus
5.3 Make measurements
Select alternative with the key.
Then press
Leakage current measurement (see 5.3.1)
Read surge counter data (see 5.3.2)
Resistive leakage current measurement (see 5.3.3)
Total reading (all of the above see 5.3.4)
Back to main meny
5.3.1 Leakage current measurement
Select sensor ID to read data from with the
Start the reading by pressing
A successful transmission is marked with
A failed transmission is marked with
If the transmission was unsuccessful, an error code
will be displayed.
Back to read data menu
5.3.2 Read surge counter data
Select sensor ID to read data from with the key.
Start the reading by pressing
A successful transmission is marked with
A failed transmission is marked with
If the transmission was unsuccessful, an error code
will be displayed.
Back to read data menu

A
A
Progress bar Error code
Progress bar Error code