Need help?Do you have a question about the ABB FMBA-01 and is the answer not in the manual?
General| Rated supply voltage | 24 V DC |
|---|---|
| Degree of protection | IP20 |
| Product name | Fieldbus Module |
| Function | Fieldbus communication |
| Fieldbus Protocols | PROFIBUS DP |
| Supply voltage range | 19.2 V DC to 30 V DC |
| Current consumption | Typically 100 mA |
| Relative Humidity | 5 ... 95 %, no condensation |
| Storage Temperature | -40°C to +85°C |
General safety instructions for installing and operating the FMBA-01 module.
Essential safety precautions for electrical installation and maintenance work on the drive.
Identifies the target readers for this manual and their expected knowledge.
Prerequisites and necessary preparations before commencing installation.
Outlines the topics covered in the manual for wiring, configuration, and use.
Explains the RS-485 serial interface standard for communication over twisted-pair cable.
Details the FMBA-01 as an optional device for ABB drives connecting to an RS-485 network.
Specifies the compatibility of the FMBA-01 with RS-485 compliant stations.
Lists the items included in the FMBA-01 Modbus Adapter module package.
Instructions for physically installing the FMBA-01 module onto the drive.
Guidelines for routing bus cables away from motor cables to prevent interference.
Details the wiring for the RS-485 connection via connector X1 on the module.
Explains how to configure bus termination using jumper J1 for signal integrity.
Provides physical dimensions, enclosure, and connector details for the module.
Covers general, compatible devices, medium, topology, and transfer rate for the link.
Describes the function of the HOST, RXD, and TXD diagnostic LEDs on the module.
To Next Page
