Need help?Do you have a question about the ABB FOX61 Series and is the answer not in the manual?
General| Series | FOX61 Series |
|---|---|
| Manufacturer | ABB |
| Protection Class | IP20 |
| Communication Interfaces | Ethernet |
| Input Voltage | 24 V DC |
Safety advice for equipment handling and adherence to safety requirements as defined in EN 60950.
Explains symbols used in the manual for warnings, operating trouble, and significant information.
Details electrical interfaces and circuit categories according to EN 60950-1 and ITU-T G.703.
Records changes and release information for the document, starting with the first release in December 2012.
Describes the LEDE1 unit's architecture, functions, and applications as an access or transport unit.
Shows the physical hardware of the LEDE1 unit, highlighting front plate features like LEDs and connectors.
Discusses how certain FOX61x functionalities are subject to feature licenses.
Lists the primary functions and supported standards of the LEDE1 unit, including interfaces and transport modes.
Lists essential safety advice and valid hardware/software combinations required before installation.
Specifies the available slots for the LEDE1 unit in FOX615 and FOX612 subracks.
Provides information about the compatibility of the LEDE1 unit with other FOX61x units.
Details how to connect cables, including the front connector and specific cable types.
Describes the supported P12 traffic signal formats and termination modes for the E1 ports.
Details specific P12 terminated transport modes like PCM30, PCM30C, PCM31, and PCM31C.
Explains transparent and clock master transport modes for P12 signals, handling clock and data.
Details the 1+1 subnetwork connection protection (SNCP) features for P12 and P0-nc signals.
Guides the commissioning of an E1 port on the LEDE1 unit, including prerequisites and configuration.
Lists prerequisites such as CESM1 unit, valid ESW, and FOXCST setup for E1 port commissioning.
Outlines the step-by-step procedure for configuring an E1 port on the LEDE1 unit.
Describes the LEDs on the LEDE1 unit front panel used for alarm and traffic status indication.
Explains the maintenance feature to apply loops (Front-to-Front, Back-to-Back) in the E1 port managed object.
Covers unit maintenance procedures including inventory data retrieval and embedded software updates.
Introduces the managed objects, properties, and commands for the LEDE1 unit within the FOXCST framework.
Details managed objects and functions for the LEDE1 unit's main access point, including Overview, Main, and Fault Management.
Details managed objects and functions for specific E1 ports, covering Overview, Main, Configuration, Fault Management, and Status.
Details managed objects and functions for channels, including Main, Configuration, Fault Management, Performance Management, and Status.
Provides a comprehensive list of associated documents relevant to the FOX61x system and LEDE1 unit.
To Next Page
