ABB FMBA-01 - Mechanical installation; Mounting

Mechanical installation
15
Mechanical installation
WARNING! Follow the safety instructions given in this manual and
the drive documentation.
Mounting
The FMBA-01 Modbus Adapter module is to be inserted into its
specific position in the drive. The module is held in place with
plastic pins and one screw. The screw also provides the earthing
of the fieldbus cable shield connected to the module.
On installation of the module, the signal and power connection to
the drive is automatically made through a 20-pin connector. (All
drives do not use all the available signals so the connector on the
drive may have fewer pins.)
Mounting procedure:
• Insert the module carefully into its position on the drive.
• Fasten the screw.
Note: Correct installation of the screw is essential for fulfilling the
EMC requirements and for proper operation of the module.