Operation Manual / A130-H.. - A140-H..
6 Operation and service / 6.4 Stopping the engine
© Copyright 2021 ABB. All rights reserved. HZTL4030_EN Rev.G July 2021
6.4 Stopping the engine
CAUTION
Residual heat in the turbocharger
If the residual heat in the turbocharger is not adequately dissipated, it may
damage the engine.
u Adequate cooling of the turbocharger must be ensured after stopping
the engine.
Water-cooled turbocharger variant
u Post-lubricate as long as the rotor is turning.
u Observe the oil pressure while performing post-lubrication: 0.5 <p
oil
≤1.0.
u Switch off post-lubrication as soon as the rotor is stationary or after no more than two
minutes.
Deviating procedures must be coordinated with ABB Turbocharging.
Page 59 / 122
To Next Page
Loading...
Need help?
General
