ABB IRB 360 - Page 110

GILLETTE ŁÓDŹ
Robotic station for packing FFS1 dispensers
Figure 57 Lubrication points for gripper guides
2. FESTO DGC-K linear actuators
Lubricate the guides directly on the surface. When lubricating, avoid direct
contact of the guide with your hand (corrosion may occur where touched) - it is
recommended to use a latex glove. It is recommended that the guides be covered
with a thin lubricant filter at all times.
Lubrication points
Type of grease
Quantity
Frequency
● PS1_EVACCUATOR
1
● PS2_EVACCUATOR
1
684474 LUB-KC1
Thin layer
Once a month
Figure 58 Lubrication point for a rodless actuator
3. FESTO FENG-32 guides
Lubricate the guides directly on the surface. When lubricating, avoid direct
contact of the guide with your hand (corrosion may occur where touched) - it is
recommended to use a latex glove. It is recommended that the guides be covered
with a thin lubricant filter at all times. Only the guides should be lubricated - the
actuator piston rod does not require lubrication.
Lubrication points
Type of grease
Quantity
Frequency
ABB Sp. z o.o.
Side 110/135
DTR_GILLETTE_ZSDPD_Farmores1_IRB360_2015_v03