ABB IRB 360 - Maintenance and Lubrication Schedule

GILLETTE ŁÓDŹ
Robotic station for packing FFS1 dispensers
To open the grille, use the blue flap and then open the grille by pulling it
towards you as shown in the photo below.
Figure 56 Replacing air filters
6.3. MAINTENANCE AND LUBRICATION
MAP OF LUBRICATION POINTS
1. Grapples
It is recommended to lubricate the guides directly around the bearings - the
points are detailed in the drawing below. When lubricating, avoid direct contact of
the guide with your hand (corrosion may occur where touched) - it is
recommended to use a latex glove. It is recommended that the guides be covered
with a thin lubricant filter at all times.
Lubrication points
Type of grease
Quantity
Frequency
Guides around the
bearings:
● GRIPPER1 (4s)
● GRIPPER2 (8s)
Mobilgrease FM
222/Dynalub 510
(DIN Performance
Claim KP2K-20)
Thin layer
Once a month
ABB Sp. z o.o.
Side 109/135
DTR_GILLETTE_ZSDPD_Farmores1_IRB360_2015_v03