GILLETTE ŁÓDŹ
Robotic station for packing FFS1 dispensers
Figure 72 Setting the grinder trigger sensor 2
The operating range of the sensors triggering the rotation of the grinder is 30-100
mm, therefore the sensor should be installed at a distance of approximately 35 mm
from the detected object (dispenser) as shown in the drawing. Additionally, due to the
pressure, the dispenser located in the "pocket" rises up, so for stable operation of the
sensor, the sensor must be positioned so that the spot hits the lower edge of the
raised dispenser.
ABB Sp. z o.o.
Side 119/135
DTR_GILLETTE_ZSDPD_Farmores1_IRB360_2015_v03
To Next Page
Loading...
