NoteAction
Tightening torque on lock nuts:
• 120 Nm
Apply locking liquid on the lock nuts (KM10).
Note
Do not apply locking liquid on the shafts!
9
Lubricating, piston rod
Use this procedure to lubricate the balancing device piston rod.
NoteAction
Position axis 2 so that the balancing device is hori-
zontal and the piston rod is extended to the greatest
extent possible.
1
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working area.
2
Clean piston rod with isopropanol before applying
new grease.
3
Type of grease is specified in
Required equipment on page 140.
Apply new grease.4
Product manual - IRB 760 141
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
3 Maintenance
3.5.1 Lubricating balancing device bearings and piston rod
Continued
To Next Page
Loading...
