ABB M1M 20 - Page 21

21
x3
x9
x1
1
2
M1M 20 POWER METER USER MANUAL
5.3.Data entry
Some of the pages require the entry of numerical characters (0-9) in the Configuration mode. In these
cases the display will show an active field identified by a flashing number.
Data entry procedure
The data entry procedure is as follows:
1. Press “Up” to increase the numerical characters from 0 to 9, until the required character is obtained.
• How to: Go back to a previous number
If during the data entry the desired number is exceeded by mistake, it is needed to increase the displayed
number until data entry starts again from 0.
• Add a second digit
2. Press “Down” to move the cursor in order to add a second digit to the number;