EasyManuals Logo

ABB M2A Series User Manual

ABB M2A Series
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
44 – EN ABB Motors and Generators | 3GZF500730-70 rev. C RU-EN 01-2016
7.2.4 Lubricants
WARNING
Do not mix different types of grease.
Incompatible lubricants may cause bearing
damage.
When regreasing, use only special ball bearing grease with
the following properties:
good quality grease with lithium complex soap and with
mineral- or PAO-oil
base oil viscosity 100-160 cST at 40 °C
consistency NLGI grade 1.5 – 3 *)
temperature range –30 °C – +140 °C, continuously.
*) A stiffer end of scale is recommended for vertical mount-
ed motors or in hot conditions..
The above mentioned grease specification is valid if the
ambient temperature is above –30 °C or below +55 °C,
and the bearing temperature is below 110 °C, otherwise
consult ABB regarding suitable grease.
Grease with the correct properties is available from all
major lubricant manufacturers.
Admixtures are recommended, but a written guarantee
must be obtained from the lubricant manufacturer, espe-
cially concerning EP admixtures, that admixtures do not
damage bearings or the properties of lubricants at the
operating temperature range.
WARNING
Lubricants containing EP admixtures are not recom-
mended in high bearing temperatures in frame sizes
280 to 450.
The following high performance greases can be used:
Mobil Unirex N2 or N3 (lithium complex base)
Mobil Mobilith SHC 100 (lithium complex base)
Shell Gadus S5 V 100 2 (lithium complex base)
Klüber Klüberplex BEM 41-132 (special lithium base)
FAG Arcanol TEMP110 (lithium complex base)
Lubcon Turmogrease L 802 EP PLUS
(special lithium base)
Total Multiplex S2 A (lithium complex base)
Rhenus Rhenus LKZ 2 (lithium complex base)
NOTE!
Always use high speed grease for high speed 2-pole
machines where the speed factor is higher than
480,000 (calculated as Dm x n where Dm = average
bearing diameter, mm; n = rotational speed, r/min).
The following greases can be used for high speed cast
iron motors but not mixed with lithium complex greases:
Klüber Klüber Quiet BQH 72-102 (polyurea base)
Lubcon Turmogrease PU703 (polyurea base)
If other lubricants are used, check with the manufacturer
that the qualities correspond to those of the above men-
tioned lubricants. The lubrication intervals are based on
the listed high performance greases above. Using other
greases can reduce the interval.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABB M2A Series and is the answer not in the manual?

ABB M2A Series Specifications

General IconGeneral
BrandABB
ModelM2A Series
CategoryEngine
LanguageEnglish

Related product manuals