M4M FIRMWARE UPDATE
5 /10
3 FW update procedure via EPiC desktop
A. Make sure you have a MyABB account. If not, please register on MyABB to
activate an account.
TIP: In case of Modbus master device in the RS-485 architecture
(e.g. PLC), the master should be disabled in order to use EPiC
desktop and perform the FW update
B. Open EPiC desktop in the “Scan” tab
C. Configure the scanning via communication protocol
1. Via Modbus RTU (M4M Modbus)
Click on “Configure” under Serial port.
Select port name, baudrate, parity, slave addresses of all devices
connected via Modbus RTU to be updated.
Press “OK”.
To Next Page
Loading...
