ABB Navigator 600 Series - Page 47

Navigator 600 Series Analyzers
Silica and Phosphate Appendix B – Acyclic Parameter Mapping
IM/NAV6PBS Issue 1 45
Octet Bit Description Diagnosis Mask (1 = enabled)
DIAGNOSIS
1 0 Hardware failure – electronic 1
1 Hardware failure – mechanical 0
2 Motor temperature too high 0
3 Electronic temperature too high 1
4 Memory error 1
5 Failure in measurement 1
6 Device not initialized (no self-calibration) 0
7 Self-calibration failed 0
2 0 Zero point error (limit position) 0
1 Power supply failed 1
2 Configuration not valid 1
3 New start-up (warm startup) carried out 0
4 Re-start (cold startup) carried out 0
5 Maintenance required 1
6 Characterization invalid 0
7 Identification number violation 0
3
4
Table B.2 Diagnostic Data (Sheet 1 of 3)