ABB NE810 - Page 10

* Refer to Safety.
** To minimise the risk of interference, a shielded cable is recommended when the cable is located inside 3 m boundary
or the cable is longer than 30 m and inside 10 m boundary to the rails and connected to this port.
10 3BSE080633
Ethernet TX Console
Electrical
specication
IEEE std 802.3. 2005 Edition Electrical specication TTL-level
Data rate
10 Mbit/s, 100 Mbit/s, manual
or auto
Data rate 115.2 kbit/s
Duplex Full or half, manual or auto Data format
8 data bits, no
parity, 1 stop bit,
no ow control
Circuit type TNV-1 Circuit type SELV
Transmission
range
Up to 150 m with CAT5e cable
or better*
Connection
2.5 mm jack,
use only ABB
cable
3BSE080212R1
Isolation to All other SFP Transceivers
Connection RJ-45, auto MDI/MDI-X See separate data sheet
Shielded cable
Not required, except when
installed in Railway applications
as signalling and telecommuni
-
cations apparatus and located
close to rails.**
Conductive
housing
Yes
Number of ports 8