What to do if I see ALARM_OPEN_1 on my ABB Switch?
If you're encountering ALARM_OPEN_1 with your ABB Switch, try resetting it using the RESET key. However, if the alarm persists, it indicates a potential malfunction within the protection device, necessitating its replacement.
What to do if I see ALARM_OPEN_2 on my ABB ATS021 Switch?
In case of ALARM_OPEN_2 on your ABB Switch, attempt to reset the system using the RESET key. Should the alarm continue, it suggests a fault in the protection device, which would then require replacement.
What to do if I see ALARM_CLOSE_1 on my ABB Switch?
If your ABB Switch displays ALARM_CLOSE_1, you can attempt to clear it by using the RESET key. If the alarm remains active after the reset, it means that the protection device may be defective and needs to be replaced.
What to do if I see ALARM_CLOSE_2 on my ABB ATS021?
When ALARM_CLOSE_2 appears on your ABB Switch, your first step should be to reset it using the RESET key. If the alarm doesn't go away after resetting, it points to a possible problem with the protection device, meaning it should be replaced.
What to do if Closure 1 Alarm occurs on my ABB ATS021 Switch?
If a Closure 1 Alarm occurs, you can try resetting the alarm using the RESET button. However, if the alarm persists after resetting, it is likely that there is a malfunction within the protection switch.
What to do if Closure 2 Alarm occurs on my ABB ATS021?
If a Closure 2 Alarm appears, attempt to reset it using the RESET button. If the alarm doesn't clear after resetting, it probably indicates a malfunction in the protection switch.
What to do if Opening 1 Alarm occurs on my ABB Switch?
In the event of an Opening 1 Alarm, you can attempt to reset the alarm by pressing the RESET button. If the alarm continues, it suggests a potential malfunction in the protection switch.
What to do if Opening 2 Alarm occurs on my ABB Switch?
If an Opening 2 Alarm is triggered, the alarm can be reset using the RESET button. If the alarm isn't cleared, it may indicate a malfunction in the protection switch.
Describes the automatic switching sequences between Line 1 and Line 2, including delays and generator control.
Guides on selecting and operating the ATS021 in Manual Mode using the Lim rotary switch.
Explains how to select and operate the ATS021 in Automatic Mode via the Lim rotary switch.
Details how to set ATS021 parameters using DIP switches and rotary switches.
Explains parameter configuration using DIP switches S23 (voltage, frequency) and S24 (neutral, phase).
Covers operating voltage, frequency, and phase settings for connecting the power circuit.
Presents a detailed diagram and explanation of the ATS021's control circuit connections.
To Next Page
General
