ABB NEXUS Series - Mounting the NEXUS Series Device on the Wall

NEXUS Series | Installation and configuration
©ABB 2021 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
11
MAN0125 Rev 20
MOUNTING THE NEXUS SERIES DEVICE ON THE WALL
You can mount the NEXUS Series device on a wall by using mounting brackets (sold separately).
1. Secure the two mounting brackets to the back of the
NEXUS Series device by using four screws.
2. Drill four holes in the wall that correspond to the
holes in the mounting bracket, then place the
NEXUS Series device against the wall and align the
holes in the mounting brackets with the holes in the
wall.
3. Tighten the screws to secure the NEXUS Series
device to the wall.