ABB NEXUS Series - Mounting the NEXUS Series Device on a DIN Rail

NEXUS Series | Installation and configuration
©ABB 2021 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
12
MAN0125 Rev 20
MOUNTING THE NEXUS SERIES DEVICE ON A DIN RAIL
The NEXUS Series device can be mounted on a DIN rail. The DIN rail bracket mounts to the back of the NEXUS
Series device.
1. Align the screw holes on the DIN rail mount
to the back of the NEXUS Series device,
place the screws on the DIN rail mount and
secure it to the NEXUS Series device.
4. Pull down on the tab to release the latch on
the DIN rail mount.
5. Mount the NEXUS Series device on a DIN
rail.
6. Secure the NEXUS Series device to the DIN
rail by pressing the latch.