ABB NOCH0070-6 Series - Connection Detail Photos

Installation
20
Detail photos of the NOCH0120-6 connection
Isolate the ends
of the cable lugs
with insulating
tape or shrink
tubing.
PE
NOCH0120-6x: Cable lug installation
[16to70mm
2
(6 to 2/0 AWG) cables]
NOCH0120-6x: Cable terminal installation
[95to185mm
2
(3/0 to 350 AWG) cables]
a. Connect the cable to the terminal.
b. Connect the terminal to the drive.
WARNING! If the wire size is less
than 95 mm
2
(3/0 AWG), a cable lug
must be used. A cable of wire size
less than 95 mm
2
(3/0 AWG)
connected to this terminal will
loosen and may damage the drive.
PE
b
a