Need help?Do you have a question about the ABB PSE 170 and is the answer not in the manual?
General| Rated Operational Current - In-Line Connection (Ie) | 170 A |
|---|---|
| Output current | 170 A |
| Protection class | IP20 |
| Weight | 5.5 kg |
| Ramp Time | 1 ... 30 seconds |
| Certifications | CE, UL, CSA |
| Operating temperature range | -25°C to +60°C |
| Initial Voltage During Start | 30 ... 70 % |
Detailed steps for initial connection, configuration, and startup procedures.
Instructions for making electrical connections, including power and control circuits.
Steps for connecting the main power circuit to the softstarter terminals.
Guidance on connecting the control supply voltage and control circuits.
Outlines the different methods for setting parameters and general precautions.
Provides a comprehensive list of all settable parameters, their ranges, and access methods.
Details various functions like Rated Current, Ramp Times, Overload Protection, and Fieldbus Control.
Introduces the troubleshooting chapter and how to use it for problem resolution.
Summarizes indications for protections, faults, and failures in various motor control states.
Lists and explains the various event codes and their corresponding causes.
Addresses issues that may occur during the initial startup phase of the softstarter.
Covers common problems and faults related to motor behavior and parameter settings.
Details specific fault codes and their possible causes and solutions, including LED and LCD indicators.
Explains indications related to motor overload, underload, and locked rotor protections.
Lists and describes failure codes, particularly related to parameter transfer and keypad operations.
Shows the wiring diagram for the softstarter using a fuse and contactor.
To Next Page
