ABB PSTX720 - Page 186

186 Index | Installation and commissioning manual | 1SFC132081M0201
PTC/PT100 input 44
Q
Quick start 11
R
Ramp current limit 79
Real time clock 66
Receive, unpack and check 30
Relay outputs 87
Replace backup 63
Reset operating data 67
Reset to defaults 67
R\L-key 51, 54
Run 62
S
Scale value range 57
Selection list 52
Selection softkeys 51
Semi-conductor fuses 22
Sequence start 83
Service and repair 136
Settings 64, 118
• Date and time 66
• Display settings 66
• Language 65
• Reset to defaults 67
Short circuit fault 111
Short circuit warning 108
Signal 56
Signal max 57
Signal min 57
Slow speed 81
Softstarter overview 20
Softstarter ratings 23
Softstarter states 70
• Individual function 70
• Pre-start 70
• Stand by 70
• Start ramp 71
• Stop ramp 71
• Top of ramp 71
Special feature 115
• Emergency mode 115
• Limp mode 116
• Line contactor close time 116
• Start without start command 116
• Step down level 117
• System mode 117
• TOR relay delay time 117
Specifications 21
Stand by 70
Stand still brake 78
Start and Stop - terminals 13, 14, 18, 19, 20, 21 39
Start key 51, 54
Start ramp 71
Start without start command 116
Step down level 117
Stop key 51, 54
Stop ramp 71
Storage 21, 22
System info 64
System mode 117
T
Table Application settings 119
Technical data 22
Technical data for external keypad 22
Temperature 9, 21, 22
Temperature errors in °C / K 45
Temperature sensor 89
• External thermal sensor - PT100 protection 100
• External thermal sensor - PTC protection 100
• PT100 89
• PTC 89
• Thermistor switch 89
Temperature sensors 100
The numerical setting 52
Thyristor 9
Thyristor overload fault 112
Thyristor overload warning 105
Tightening torques and cable dimensions 37
Too long current limit protection 101
Top level 54
Top of ramp 71
Shunt fault TOR 9
Torque ramp 74
• Torque stop ramp 76
Torque start ramp 75
Torque stop ramp 76
TOR relay delay time 117
Total Harmonic Distortion (THD) warning 107
Troubleshooting 139
• Overview of faults, protections and warnings 143
• Protection indication shown on screen 145
Type designation 21
U
Uc 9
Ue 9
Under voltage protection 98
Unspecified fault 113
Uploading of parameters 63
Us 9
User defined protection 19
User interface 18
V
Voltage imbalance warning 107
Voltage outputs protection 100
Voltage ramp 72
• Voltage start ramp 72
• Voltage stop ramp 73
Voltage start ramp 72
Voltage stop ramp 73
W
Warning functions 19
Warnings 62, 104
Weights 22
Wiring diagrams 151
14