ABB PVS-100-TL

TRACKSO INSTALLATION GUIDE FOR ABB PVS-100/120-TL
Brand: ABB
Type: Solar On Grid String Inverter
Models: PVS-100/120-TL
CONNECTION DIAGRAM
Figure A1 – ABB 100kW inverter Communication Port
The communication terminals (RS485) are located at the right bottom of the inverter as shown in Figure A1
Steps:
1) Loosen the 4 captive screws and locate communication module as shown in Figure A1.
2) Install the wires in the appropriate terminals. Data+ to 485+ and Data- to 485- of communication port as
shown in Figure A2
3) Tighten the gland. Make sure that the gland seals around the cable and that the cable does not move
when pulled.
Table AT1 – ABB connections with
TrackSo
ABB Pin No.
& Assignment
TrackSo Pin
No.
4
485+
3
Data +
5
485 -
4
Data -
6
RTN
-
-
1
485+
Used for
Daisy Chain
Connection
2
485-
3
RTN
Figure A2- Connection of ABB Communication port with TrackSo