ABB RED670 - Basic IED Functions

IEC 61850 or function
name
ANSI Function description Line Differential
RED670
(Customized)
RED670 (B33) RED670 (A42) RED670 (B42)
RED670 (C42)
ECPSCH 85 Scheme communication
logic for residual
overcurrent protection
0-1 1-C34 1-C34 1-C34 1
ECRWPSCH 85 Current reversal and weak-
end infeed logic for
residual overcurrent
protection
0-1 1-C34 1-C34 1-C34 1
DTT Direct transfer trip 0-1
Table 8: Number of function instances in Synchrophasor report, 8 phasors
Function name Function description Number of instances
PMUCONF Configuration parameters for C37.118 2011 and IEEE1344 protocol 1
PMUREPORT Protocol reporting via IEEE 1344 and C37.118 1
PHASORREPORT1 Protocol reporting of phasor data via IEEE 1344 and C37.118, phasors 1-8 1
ANALOGREPORT1 Protocol reporting of analog data via IEEE 1344 and C37.118, analogs 1-8 1
BINARYREPORT1 Protocol reporting of binary data via IEEE 1344 and C37.118, binary 1-8 1
SMAI1–SMAI12 Signal matrix for analog inputs 1
3PHSUM Summation block 3 phase 6
PMUSTATUS Diagnostics for C37.118 2011 and IEEE1344 protocol 1
3.5 Basic IED functions
GUID-C8F0E5D2-E305-4184-9627-F6B5864216CA v11
Table 9: Basic IED functions
IEC 61850 or function
name
Description
INTERRSIG Self supervision with internal event list
TIMESYNCHGEN Time synchronization module
BININPUT,
SYNCHCAN,
SYNCHGPS,
SYNCHCMPPS,
SYNCHLON,
SYNCHPPH,
SYNCHPPS, SNTP,
SYNCHSPA
Time synchronization
PTP Precision time protocol
Table continues on next page
1MRK 505 378-UEN A Section 3
Available functions
Line differential protection RED670 2.2 IEC 45
Commissioning manual