ABB REF601 - Menu - Measurement

1MDU07212-YN Rev. C Section 5
Use of LHMI
REF601 / REJ601 43
Application Manual
5.2.3 Menu – Measurement
Submenu Measurement shows analogue input values as primary or as secondary
values according to primary and secondary current of current transformer selected
in the submenu configuration – settings. Also it shows binary input and output
status at the relay terminal.
Primary CurrentMeasurement I1:
XXXXX.XX A
I2:
XXXXX.XX A
I3:
XXXXX.XX A
I0:
XXXXX.XX A
Secondry Current I1:XX.XX A
I2:XX.XX A
I3:XX.XX A
I0:XX.XX A
BI Status BI 1234
Status 0000
BO 123456
Status 000100
BO Status
0 – LOW
1 – HIGH
0 – Open
1 – Close
I.2:
XXX.XX %In
Counter
Count :XXXXX
ϑ:
XXX %
t motor start:
XXX.X s
Istr max:
XXXX.X A
RStr Enable t:
XXX.X min
*
*
*
Note * - only available when respective function in IED configuration
OPTS
RunTime:XXXXXhrs
*
*
*
Figure 16: Measurement menu of relay REF601/REJ601