Commands
Table 4: Command push-buttons
Name Description
Menu
• Moving directly to Main menu, if currently
in any other menu or view.
• Moving to the default view, if currently in
Main menu.
R/L
Changing the control position (remote or local)
of the device.
• When the R LED is lit, remote control is
enabled and local control disabled.
• When the L LED is lit, local control is
enabled and remote control disabled.
• When none of the LEDs are lit, both control
positions are disabled.
Clear
• Activating the Clear/Reset view.
Help
Showing the help menu.
Multipage
Opening alarm panel and selecting alarm page
from the view.
Function buttons
Table 5: Function buttons
Name Description
Function
button
Executing the defined function: OFF, menu short cut or binary control.
4.1.4 Local HMI functionality
4.1.4.1 Protection and alarm indication
GUID-09CCB9F1-9B27-4C12-B253-FBE95EA537F5 v17
Protection indicators
The protection indicator LEDs are Ready, Start and Trip.
The yellow and red status LEDs are configured in the disturbance recorder
function, DRPRDRE, by connecting a start or trip signal from the actual function
to a BxRBDR binary input function block using the PCM600 and configure the
setting to
Off
,
Start
or
Trip
for that particular signal.
Table 6: Ready LED (green)
LED state
Description
Off Auxiliary supply voltage is disconnected.
On Normal operation.
Flashing Internal fault has occurred.
Section 4 1MRK 500 127-UEN D
Overview
24 670 series
Operation manual
To Next Page
Loading...
