ABB Relion 670 series - Clearing and Acknowledging; Using the Local HMI Help

Pressing Cancel in the Save changes dialog closes only the Save changes
dialog box, but the IED remains in editing mode. All the changes applied to any
setting are not lost and the user can continue to change settings. To leave the
change setting mode, select No or Yes in the Save changes dialog.
After changing the parameters marked with !, the IED restarts automatically for
the changes to take effect.
5.1.15 Clearing and acknowledging
AMU0600425 v10
The Clear button is used to reset, acknowledge or clear all messages and indications, including
LEDs and latched outputs as well as registers and recordings. Press the Clear button to
activate a selection menu, and select the wanted clearance or reset function. Events and
alarms assigned to alarm LEDs are cleared with the Clear button as well.
1.
Press
to activate the Clear view.
IEC13000236-1-en.vsd
GUID-0CFAED62-312B-449F-BB58-D49496EA1CC8 V2 EN-US
Figure 30: Clear view
The content of the Clear menu depends on the configuration configured with PCM600.
2.
Select the item to be cleared with or .
3.
Press , select OK to confirm the selection or Cancel to cancel the selection, and press
.
4. Repeat steps 2 and 3 to clear other items.
5.1.16 Using the local HMI help
AMU0600421 v8
1.
Press to open the help view.
2.
Scroll the text with
or if the help text exceeds the display area.
3.
To close the help, press .
The help dialog is also closed when the display timeout expires.
Section 5 1MRK 500 127-UEN D
Using the HMI
44 670 series
Operation manual