ABB Relion 670 series - Activating Leds

IEC13000049-2-en.vsd
IEC13000049 V2 EN-US
Figure 58: Changing the setting value
10.
Press or to change the value.
11.
Confirm the change with
.
7.4.2 Activating LEDs
GUID-C63971C7-EDC8-40BA-B53B-7377AA33FCC5 v6
To activate the LEDs, they must be configured with PCM600.
1.
Select Main menu/Configuration/HMI/LEDs and press .
IEC13000056-2-en.vsd
IEC13000056 V2 EN-US
Figure 59: Alarm groups
The list can contain three alarm groups at the maximum. The amount of groups depends
on the amount of LEDs taken into use.
2.
Select an alarm group with
or and press .
3.
Select an Alarm LED with
or .
4.
Press to confirm the selection and to change the Alarm LED mode.
5.
Press or to change the value and to confirm the selection.
Section 7 1MRK 500 127-UEN D
Operating procedures
68 670 series
Operation manual