GUID-8A573707-899E-4F4C-B20A-931D1556F480 V1 EN-US
Figure 27: Last digit is active and it can be increased or decreased
2.
Press
to increase or to decrease the value of an active digit.
One press increases or decreases the value by a certain step. For integer values, the
change is 1, 10, 100 or 1000 (...) depending on the active digit. For decimal values, the
change can be fractions 0.1, 0.01, 0.001 (...) depending on the active digit.
For parameters with defined steps, digits smaller than the step value
cannot be edited.
3.
Press
or to move the cursor to another digit.
4. To select the minimum or maximum value, select the arrow symbol in front of the value.
•
To set the value to the maximum, press .
•
To set the value to the minimum, press
.
If the value is already at either end value (minimum or maximum), it requires two presses
to change it to the opposite end value.
After pressing , the previous value can be restored by pressing once, and vice
versa. Another press of
or sets the value to the lower or higher limit. The symbol in
front of the value is ↕, when the previous value is shown.
1MRK 500 127-UEN D Section 5
Using the HMI
670 series 41
Operation manual
To Next Page
Loading...
