ABB Relion RER615 - Adjusting the Display Contrast; Changing Display Symbols; Changing the Default View; Setting the System Time and Time Synchronization

8.4.3.2 Adjusting the display contrast
Adjust the display contrast anywhere in the menu structure to obtain optimal
readability.
•
To increase the contrast, press simultaneously and .
•
To decrease the contrast, press simultaneously and .
The selected contrast value is stored in the non-volatile memory if you are logged in
and authorized to control the protection relay. After an auxiliary power failure, the
contrast is restored.
8.4.3.3 Changing display symbols
Use the keypad to switch between the display symbols IEC 61850, IEC 60617 and
IEC-ANSI.
1. Select Main Menu/Configuration/HMI/FB naming convention and press
.
2.
Change the display symbols with or .
3.
Press
to confirm the selection.
The protection relay has to be rebooted if the WHMI display symbols
are changed. With the LHMI, the change takes effect immediately.
8.4.3.4 Changing the default view
The default view of the display is Measurements unless set otherwise.
1.
Select Main menu/Configuration/HMI/Default view and press .
2.
Change the default view with or .
3.
Press to confirm the selection.
8.4.3.5 Setting the system time and time synchronization
1. Select Main menu/Configuration/Time/System time.
2.
Select the parameter with or .
3.
Press
, change the value with or and press again.
4. Repeat steps 2 and 3 to set the rest of the system time parameters.
Section 8 1MRS758754 B
Commissioning
124 REC615 and RER615
Operation Manual