ABB REM630 - Inputs and Outputs; Access Control

1.4.2 Manual conventions
Conventions used in IED manuals. A particular convention may not be used in this
manual.
• Abbreviations and acronyms in this manual are spelled out in Glossary.
Glossary also contains definitions of important terms.
• Push button navigation in the LHMI menu structure is presented by using the
push button icons, for example:
To navigate between the options, use
and .
• HMI menu paths are presented in bold, for example:
Select Main menu/Settings.
• LHMI messages are shown in Courier font, for example:
To save the changes in non-volatile memory, select Yes and press .
• Parameter names are shown in italics, for example:
The function can be enabled and disabled with the Operation setting.
• The ^ character in front of an input or output signal name in the function block
symbol given for a function, indicates that the user can set an own signal name
in PCM600.
• The * character after an input or output signal name in the function block
symbol given for a function, indicates that the signal must be connected to
another function block in the application configuration to achieve a valid
application configuration.
1.4.3 Functions, codes and symbols
Table 1: Functions included in REM630
Functionality
IEC 61850 IEC 60617 ANSI
Protection
Three-phase non-directional overcurrent,
low stage
PHLPTOC 3I> 51P-1
Three-phase non-directional overcurrent,
instantaneous stage
PHIPTOC 3I>>> 50P/51P
Non-directional earth fault, low stage EFLPTOC I
0
> 51N-1
Non-directional earth fault, high stage EFHPTOC I
0
>> 51N-2
Non-directional earth fault, instantaneous
stage
EFIPTOC I
0
>>> 50N/51N
Directional earth fault, low stage DEFLPDEF I
0
> → 67N-1
Directional earth fault, high stage DEFHPDEF I
0
>> → 67N-2
Phase reversal PREVPTOC I
2
>> 46R
Three-phase thermal overload for motors MPTTR 3Ith>M 49M
Loss-of-load supervision LOFLPTUC 3I< 37
Motor stall protection JAMPTOC Ist> 51LR
Emergency start ESMGAPC ESTART ESTART
Table continues on next page
1MRS756785 A Section 1
Introduction
REM630 7
Application Manual