ABB SACE Emax 2 - Default Parameters; Ekip Dip Default Parameters

ABB | SACE Emax 2
52 | © 2017 ABB | 1SDH000999R0002 - ECN000058721 - Rev. B
Ekip Dip protection trip unit | 8 - Default parameters
8 - Default parameters
Ekip Dip default parameters
The Ekip Dip trip units are supplied with the following default parameters, some adjustable with the front DIPs
(protections, Frequency, Neutral), other via front bus.
Protection/Parameter Value
L 1 In; 144 s
S
(1)
Off; 0.1 s
I 4 In
G
(1)
Off; 0.1 s
Frequency 50 Hz (IEC) / 60 Hz (UL)
Neutral
Off (for three-pole circuit breakers).
50 % (for four-pole circuit-breaker)
Hardware Trip Disabled
Monitor time 5 minutes
Local Bus Disabled
Alive LED Disabled (Power-on LED fixed)
Maintenance Off
(1)
S Protection available with LSI and LSIG versions of the trip unit. G Protection available with LSIG version.