ABB SACE Emax 2 - PLP: Padlock in Connected;Test;Disconnected Positions; KLP: Key Lock for Connected;Test;Disconnected Positions; KLP Lock Additional Accessory

ABB | SACE Emax 2
Mechanical accessories | 2 - Mechanical safety accessories
87 | © 2017 ABB | 1SDH000999R0002 - ECN000058721 - Rev. B
PLP: padlock in connected/
test/disconnected positions
The PLP locks the moving part of a withdrawable circuit-breaker in the fixed part, in one of the following
positions:
• connected
• test
• disconnected
Only one type is available that allows you to mount up to three padlocks with a diameter of 8 mm.
NOTE: the PLP lock can also be supplied in the presence of a KLP lock
Information on the assembly is available on the web site http://www.abb.com/abblibrary/DownloadCenter/,
in particular with the kit sheet 1SDH000999R0707.
KLP: key lock for connected/
test/disconnected positions
The KLP lock for connected/test/disconnected position locks the moving part of a withdrawable circuit-
breaker in the fixed part, in one of the following positions:
• connected
• test
• disconnected
NOTE: it is possible to lock the moving part in the disconnected position only by using the
additional accessory KLP lock.
The KLP lock for connected/test/disconnected positions is available with two types of lock:
• lock with different key code numbers (for a single circuit-breaker).
• lock with the same key code number (for more than one circuit-breaker). The maximum number of key
code numbers available is five.
Through an appropriate setup, the KLP lock for connected/test/disconnected positions can work with three
other types of lock:
• Ronis
• Profalux
• Kirk
• Castell
The maximum number of locks that can be installed per circuit-breaker is the two, for all types of lock.
NOTE: the supply of Ronis - Profalux - Kirk locks is at customer's expense.
NOTE: the KLP lock can also be supplied in the presence of a PLP lock
Information on assembly is available on the web site http://www.abb.com/abblibrary/DownloadCenter/, in
particular with the kit sheets:
• 1SDH000999R0704 for key locks with lock supplied by ABB;
• 1SDH000999R0705 for the key locks with pre-engineering for Ronis - Profalux - Kirk locks;
• 1SDH000999R0719 for the key locks with pre-engineering for Castell locks;
KLP lock additional accessory
This additional accessory limits the locking function to the disconnected position only.
Information on the assembly is available on the web site http://www.abb.com/abblibrary/DownloadCenter/,
in particular with the kit sheet 1SDH000999R0727.