ABB SACE Emax E4.2 - Main Page; Start Page

ABB | SACE Emax 2
8 | © 2018 ABB | 1SDH001316R0002 - ECN000086018 - Rev. C Ekip Touch protection trip unit | 1 - Layout of the interface
Continued from the previous page
The following table provides a description of the various areas of the bar:
Pos. Description
A
It shows the type of message:
•
Alarm
•
Warning, error, or prealarm
•
Information
•
Active timing
B It displays the active messages one by one in a loop.
C ABB logo.
The complete list of messages is given on page 22.
Main page
To open the page, press the key HOME.
The page appears as follow:
Figure 4
The following table provides a description of the various areas of the page:
Pos. Function
A It opens the Histograms page.
B It opens the Menu page.
C It opens the Measuring instruments page.
D It opens the Measurements page.
E In the presence of messages, it opens the Alarm List page.
Start page
To open the page, press the HOME key until the page is displayed.
The system returns automatically to this page after some minute of inactivity.
The default start page is the page Histograms.
Any graphical level 2 page (accessible from the main page) can be set as the start page, except for the
pages Alarm List and Menu.
To set a page as the start page, you need to:
1. Open the page
2. Keep the HOME key pressed for at least 5 seconds.
3. Select Yes in the confirmation window that appears on the display.