ABB Symphony Harmony Series - Function Code 216 Modifications; IMASI03 Three Pin Jumper Locations; IMASI23 Six Pin Jumper Block Configuration

C - 2 WBPEEUI240774A0
Function Code 216 Modifications
Function Code 216 Modifications
The following change is required to function code 216 when
replacing an IMASI03 module with an IMASI23 module.
• Change specification S11 to 24 bit A/D conversion resolu-
tion.
Refer to Table 1-4 for typical analog to digital conversion rates.
The rate specified is the conversion time for all channels.
NOTE: If 16, 18, 20, or 22 bits resolution is already selected in function code
216, the IMASI23 module will automatically default to the 24 bit resolution. This
change is only necessary to insure the specifications accurately reflect the
module capabilities.
Figure C-1. IMASI03 Three Pin Jumper Locations
Figure C-2. IMASI23 Six Pin Jumper Block Configuration
STATUS
LED
EDGE
CONNECTORS
P1
P3
P2
IN PU T
CHANNEL 1
IN PUT
CHANNEL 16
DEFAULTS
J2 J1
J1 J31
J2 J32
3
2
1
SW1
ADDRESS SWITCH
OPEN
SW1
12345678
SET JUMPER PAIR TO PINS 1 AND 2
FOR VOLTAGE AND CURRENT INPUT
SET JUMPER PAIR TO PINS 2 AND 3
FOR RESISTANCE INPUT
T04431A
mV/TC V/mA RTD
T04355A