ABB TPL65-A32 - Page 103

Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
Taking out of operation at short notice
9
Locking the rotor
9.2
Page 101
September 2014 HZTL2498_EN Revision A
Locking rotor TPL65-A32 / A33 / A36
 Remove silencer or air suction branch.
NOTICE
Carry out work as described in chapter Removing and fitting.
 Insert locking flange (94003) into compressor wheel.
 Position screws (94007) in unused threaded holes of compressor
wheel and tighten them as specified in following
Table of tightening
torques
.
CAUTION
Don't remove any balancing screws from compressor wheel. Use only
unoccupied threaded holes to fit lifting device.
 Position assembly / disassembly device (90020) over studs (72026)
and locking flange (94003).
 Turn compressor wheel so that locking flange hexagon aligns with
hexagon in assembly / disassembly device (90020).
 Tighten nuts (74027) complete with washers (72018) on compressor
casing as specified in following
Table of tightening torques
.
© Copyright 2014 ABB. All rights reserved.