ABB TPL85-B14 - Fitting gas inlet casing

Operation Manual / TPL85-B14/-B15/-B16
Disassembly and assembly
8
Fitting gas inlet casing
8.8
Page 105
© Copyright 2016 ABB. All rights reserved.
May 2016 HZTL2491_EN Revision B
Fitting gas inlet casing
8.8
 Fit the cover ring (51085) with the help of the two guide studs (90320).
CAUTION
Positioning the cover ring
Align the marking "TOP" on the cover ring (51085) with the position of
the gas outlet flange.
 Make certain to install the cover ring in the correct position.
 Coat the screw threads with high-temperature grease.
 Screw in and tighten the screws (57005).
 Remove the guide studs (90320).
 Mount the nozzle ring (56001) on the gas inlet casing (51001) using
the screws (56014) and sleeves (56013).
 Fit gas inlet casing (51001) complete with nozzle ring to gas outlet
casing (61001) using screws (61044).
 Remove lifting gear complete with shackle (90195).
 Fit insulation to gas inlet casing (51001).
8.8
If removed: