ABB TPL85-B14 - Troubleshooting; Malfunctions when starting

Operation Manual / TPL85-B14/-B15/-B16
Troubleshooting
6
Malfunctions when starting
6.1
Page 77
© Copyright 2016 ABB. All rights reserved.
May 2016 HZTL2491_EN Revision B
Troubleshooting
Malfunctions when starting
6.1
Sluggish start-up
Possible causes
Elimination
Turbo-
charger
Turbocharger contaminated Clean it
Damaged bearing Contact an ABB Turbocharging
Service Station
Rubbing rotor
Foreign object in turbocharger
Vibrations
Possible causes
Elimination
Turbo-
charger
Rotor unbalance Contact an ABB Turbocharging
Service Station
Damaged turbine or compressor
Damaged bearing
Rubbing of rotating parts
Normal behaviour, no malfunction
Turbo-
charger
Minor uniform wear around the periphery of rotor components,
caused by slight local rubbing of adjacent components, is permis-
sible. The compressor blades and turbine blades are then short-
ened somewhat. Certain tolerances must be observed to avoid a
significant loss of efficiency.
 If there is any doubt about the extent of rubbing, then an ABB
Turbocharging Service Station must be contacted.
 Have a dimension check carried out by an ABB Turbocharging
Service Station.
6
6.1