ABB TPL85-B14 - Page 110

Operation Manual / TPL85-B14/-B15/-B16
Disassembly and assembly
8
Fitting internal part of compressor
casing
8.9
Page 108
© Copyright 2016 ABB. All rights res
erved.
May 2016 HZTL2491_EN Revision B
CAUTION
Locked safety segments (76080) during assembly
The safety segments (
76080
) are not in the operating position. Addi-
tional axial securing of the two compressor casings (74000/76000) is
not guaranteed.
 Fit four nuts (74027) complete with washers (74018), equally spaced
around circumference, and tighten.
 Unscrew the nuts (90458) on threaded studs of
three
safety segments
(
76080
) on the compressor casing internal part (76000).
The compressor casing internal part (76000) is now secure relative to the
compressor casing external part (74000).
NOTICE
Note control dimension (s). The safety segments (76080) are again in
the operating position.
Dimension
TPL85-B
s
18.5
 Put the nuts (90458) back in the toolbox.
Position of the safety
segments after assembly
Control dimension (s)
[mm]