Assembly Instructions / TPR56FV.. - TPR61FV..
2 Safety / 2.2 Lifting loads
© Copyright 2018 ABB. All rights reserved. HZTL455311P0033_EN Revision B May 2018
2.2 Lifting loads
WARNING
Suspended loads
Loads not suspended in compliance with regulations may lead to personal
injury or accidents with fatal consequences.
u Loads must always be fastened to technically perfect lifting gear with
sufficient loading capacity.
u Make sure the load is suspended properly on the crane hook.
u Do not let anyone stand beneath a suspended load.
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
If there are two or more suspension points, the attachment angle of 45° must not be ex-
ceeded. This prevents excessive loading due to diagonal pull.
u Use a suitable edge guard if there are sharp edges.
u The assembly devices must be completely screwed in and must not unscrew during use.
u Use assembly devices only for the described applications.
Page 6 / 17
To Next Page
Loading...
