Operation Manual / TPS44-F.. - TPS61-F..
5 Maintenance / 5.4 Cleaning components mechanically
© Copyright 2020 . All rights reserved. HZTL2412_EN Rev.G March 2020
Cleaning the compressor end
CAUTION
Selection of the cleaning agent
Cleaning agents that contain chlorine corrode metals.
u Only use pH-neutral cleaning agents that do not corrode metals.
u Observe the material safety data sheet.
u Observe country-specific regulations regarding banned and restric-
ted substances.
CAUTION
Water and contamination in the cartridge group
If water or contamination penetrates the cartridge group, this can im-
pair the function of the turbocharger and damage parts inside the cart-
ridge group.
u Make sure that no water or contamination can enter into the cart-
ridge group.
u Clean compressor wheel with a cloth or soft brush soaked in water
with household detergent. Do not use any wire brushes!
u Dry the compressor wheel and the gap between the compressor and
the bearing casing with a weak jet of compressed air.
u Lightly spray the compressor wheel and the gap between the com-
pressor and the bearing casing with penetrating oil.
u Dispose of dirty water and cleaning agent in accordance with the
safety data sheet.
Page 62 / 113
To Next Page
Loading...
