12
Hold the blood drop to the white area until the meter beeps (if sound is on) and
the status bar appears on the display. This indicates the test strip has obtained
enough blood.
The countdown appears on the display as the meter checks the glucose level.
Note: Do not remove the test strip from the meter or disturb the test strip during the
countdown.
If the countdown does not start, remove and discard the used test strip, turn o
the meter and try again with a new strip.
View the Result
The meter beeps (if sound is on) when the result appears on the display. The test is
complete (example shown). The result is stored in memory.
Turn Off the Meter
Use the opened foil packet to remove the used test strip. This turns o the meter.
Discard the used test strip properly.
Note: You can also press and hold
for at least 2 seconds to turn o the meter. The
meter also turns o after 60 seconds of inactivity.
To Next Page
Loading...
