40
2. If the meter includes a plastic tab, pull on the tab to remove the battery.
If the meter does not include a plastic tab, push the battery upward to remove
it.
3. Insert a new CR 2032, lithium (coin cell) battery: (+) facing up.
4. Slide the battery cover into place until it clicks.
Note: Dispose of used batteries properly.
5. Press and hold to turn the meter on. If the meter does not turn on, check to
see that the battery was installed properly.
If meter turns on, the meter may prompt you to reset the time and date. (See
‘Setting Up the Meter’ in this user’s manual.)
Note: Test results will not be lost even if the meter loses its time and date settings.
To Next Page
Loading...
