User’s manual
The Ability system 13
2-5User Codes
Each User Code comprises a PIN for identification purposes, and a group of
parameters which determines its rank in the system code hierarchy and the
operations the user is entitled to perform.
The PIN is made up of 4, 5 or 6 digits that the user must enter in order to
allow identification.
The PIN of the only user code enabled at default is 0001. The PINs of the
successive codes are 0002, 0003, etc.
Nota Bene
The installer is not allowed to change User code PINs. The installer provides the
system users with default user PINs which they must change immediately to PIN
codes of their choice.
Each user code is characterized by the following parameters, programmed
by the installer in accordance with specific user rank.
• Partitions - User codes can control only the partitions they are
assigned to. If a user code is entered at a keypad, the user can control
only the partitions which are common to both the code and keypad
concerned. For example, if the code is enabled on partitions 1, 2, 3, 4
and 5 and the keypad is enabled on partitions 4 and 5, the user
operations will affect partitions 4 and 5 only.
• User Code Types (rank) - There are two user code types (ranks),
"Main User" and "User". "Main User" codes can disable ordinary "User"
codes and change their PINs. However, a "Main User" code cannot be
used to disable another "Main User" code or change its PIN. "User"
codes can change their own PINs only.
• Timer Restriction - If a code is associated with one of the 2 timers, it
will be able to operate the system only when the Timer is On.
• Group of outputs which can be activated/deactivated manually -
After accessing the Outputs ON/OFF section (User Menu) the user can
activate/deactivate the duly programmed outputs.
• Menu sections the user can access (refer to paragraph 2-5-1
Accessing the User Menu, point 1.).
• Customized Shortcuts - Each code can be programmed to manage:
•• up to 4 customized (personal) shortcuts assigned to keys to
•• up to 10 customized (personal) shortcuts assigned to keys
to
These shortcuts are available only after accessing the User Menu.
2-5-1
Accessing the User
Menu
In order to access your customized (personal) menu, you must type in your
PIN then press
. At this point (see figure opposite)
select with the keys
and the menu you require then press
to open it.
Following
is a the list of available User-Menu sections:
• Manage alarms
•Arm/Disarm ops.
• Activations
•View
• Outputs ON/OFF
•Set date/time
•Set Keypad
• Change PIN
• Teleservice req.
•Overtime
The user can press the keys to and
to
if these
keys are associated with shortcuts.
Type-in Code
***---
Code Rupert
Manage alarms
Arm/Disarm ops.
Activations
To Next Page
Loading...
Need help?
General